115Ø Kit (w/ Pre-Installed PC Build Surface)

Regular price: $29.00
Sale price: $24.00

Kit Size

Quantity

Size Ø115mm / Ø4.5”

*Fits: MonoPrice Mini Delta, Monoprice Mini Delta V2, and Biqu Magician Mini Delta

The Pre-Installed Flexible Build System includes:

1 Wham Bam Flexi Magnetic Base (high temp-resistant up to 150 degrees with high temp 3M adhesive)
1 Wham Bam Flexi Build Plate (spring steel) with pre-installed PC Build Surface

The Pre-Installed Double Wham includes:

1 Wham Bam Flexi Magnetic Base (high temp-resistant up to 150 degrees with high temp 3M adhesive)
2 Wham Bam Flexi Build Plate (spring steel) with pre-installed PC Build Surface

For more information on this product, click here: Flexible Build System

*Attention: It is the buyer’s responsibility to be sure the size selected will work on your machine. Measure your bed, do not rely on build volume, and see if you are happy with the size before ordering. Please keep in mind that on one side you will have a tab that sticks out another 15mm. Wham Bam is not responsible for mistaken order sizes. Learn more about machine fits HERE.

**It is the buyer’s responsibility to pay any taxes and import duties. No refunds of uncollected customs packages.

I should have bought a long time ago

this is money well spent on a great product. you just need to follow directions for installation.

Excellent Build Plate!

This is my go to build plate. Sure it is more expensive than the wannabes and takes longer for shipping, but it is well worth it. I regularly print 50 to 80 hour prints in PLA+ and would trust no other surface to hold securely for that long.

Vast Improvement

Ordered this to replace the factory build plate on my Ender 3 S1 and it's so much better. It's even better than the textured PEI build plate that came with my S1 Pro.

Cannot recommend enough. Any printer I buy in the future will get a WhamBam PEX surface.

Pretty Awesome, But....

I found this plate to be really good for the PLA and PLA + prints; however, for ABS/ASA it was not that great. I followed all directions on it and prints were still lifting from the plate. I did find that if I ran it under water and cleaned with Dawn, then dried it with paper towel, ALL my ABS/ASA prints stuck like they should. I was doing the same for the G10 plate I had, so this is not really an upgrade from that and at the pricepoint, I would have not purchased it.

PEX ROCKS

Thanks for the quality of this material.
No Lora adhesion problems.

1 2 3

Back to Flexible Build System for FDM