**This is a discontinued size, we have reduced the size to 345Ø on our current version**
Size: Ø350 / 350mm round / 13.8” round
fits: Tevo Little Monster
*Attention: It is the buyer’s responsibility to be sure the size selected will work on your machine. Measure your bed, do not rely on build volume, and see if you are happy with the size before ordering.
**It is the buyer’s responsibility to pay any taxes and import duties. No refunds of uncollected customs packages.
Customer Reviews
PEX Build Surface
Nothing has made removing prints from the bed easier. I got this as a gift and I would never go back. Say goodbye to the dreaded bed scraping to remove tough prints.
I have an Ender 5 plus that I've had lots of problems trying to get prints to stick to. The original glass bed was not sticky enough, a sheet of g10 was not sticky enough (even when roughed up with sandpaper), and a sheet of zebra skin was a bit too sticky. The wham bam PEX is perfect, though it took a few heating+cooling cycles to reach prime stickiness. I've only had one failed print since switching (and the failure happened in a known low spot on the bed). Highly recommend.
This build plate is great , I have no adhesion issues with anything.So far tried PLA,PETG ,ASA,PETG CF.
Thanks for the great product.
I have older machines that are absolute workhorses.
But the Taped unremovable plate made life difficult when the tape was new, prints had to be yeated out of the machine.
Now I just wait for the plate to cool, and the print just gently pops off the WHAMBAM PEX plate.
Also worth noting, I havent had the need to use a brim or raft for supports since getting the PEX plate for these machines.
The adheasion is incredible!
Customer Reviews
PEX Build Surface
Nothing has made removing prints from the bed easier. I got this as a gift and I would never go back. Say goodbye to the dreaded bed scraping to remove tough prints.
I have an Ender 5 plus that I've had lots of problems trying to get prints to stick to. The original glass bed was not sticky enough, a sheet of g10 was not sticky enough (even when roughed up with sandpaper), and a sheet of zebra skin was a bit too sticky. The wham bam PEX is perfect, though it took a few heating+cooling cycles to reach prime stickiness. I've only had one failed print since switching (and the failure happened in a known low spot on the bed). Highly recommend.
This build plate is great , I have no adhesion issues with anything.So far tried PLA,PETG ,ASA,PETG CF.
Thanks for the great product.
I have older machines that are absolute workhorses.
But the Taped unremovable plate made life difficult when the tape was new, prints had to be yeated out of the machine.
Now I just wait for the plate to cool, and the print just gently pops off the WHAMBAM PEX plate.
Also worth noting, I havent had the need to use a brim or raft for supports since getting the PEX plate for these machines.
The adheasion is incredible!