The Wham Bam Flexi Plate is made from high-quality flexible spring steel designed to be bent thousands of times without kinking. The spring alloy contains a high level of chromium to ensure no rust or oxidation for its lifetime. The Flexi Plate is 0.4mm thick. Build surface sold separately.
Having extra Flexi Plates on hand to do a live swap will speed up your workflow!
*Please confirm bed size on your actual machine prior to ordering, keep in mind that on one side you will have 2 tabs (1 tab on round beds) which stick out another 15mm. When in doubt cut out a piece of paper to the size of the kit you are interested in ordering and overlay this on your machine to check fit. Wham Bam is not responsible for mistaken sizes ordered. See our sizing guide.
*It is the buyer’s responsibility to pay any taxes and import duties. No refunds of uncollected customs packages.
PEX Build Surface
Nothing has made removing prints from the bed easier. I got this as a gift and I would never go back. Say goodbye to the dreaded bed scraping to remove tough prints.
I have an Ender 5 plus that I've had lots of problems trying to get prints to stick to. The original glass bed was not sticky enough, a sheet of g10 was not sticky enough (even when roughed up with sandpaper), and a sheet of zebra skin was a bit too sticky. The wham bam PEX is perfect, though it took a few heating+cooling cycles to reach prime stickiness. I've only had one failed print since switching (and the failure happened in a known low spot on the bed). Highly recommend.
This build plate is great , I have no adhesion issues with anything.So far tried PLA,PETG ,ASA,PETG CF.
Thanks for the great product.
I have older machines that are absolute workhorses.
But the Taped unremovable plate made life difficult when the tape was new, prints had to be yeated out of the machine.
Now I just wait for the plate to cool, and the print just gently pops off the WHAMBAM PEX plate.
Also worth noting, I havent had the need to use a brim or raft for supports since getting the PEX plate for these machines.
The adheasion is incredible!
PEX Build Surface
Nothing has made removing prints from the bed easier. I got this as a gift and I would never go back. Say goodbye to the dreaded bed scraping to remove tough prints.
I have an Ender 5 plus that I've had lots of problems trying to get prints to stick to. The original glass bed was not sticky enough, a sheet of g10 was not sticky enough (even when roughed up with sandpaper), and a sheet of zebra skin was a bit too sticky. The wham bam PEX is perfect, though it took a few heating+cooling cycles to reach prime stickiness. I've only had one failed print since switching (and the failure happened in a known low spot on the bed). Highly recommend.
This build plate is great , I have no adhesion issues with anything.So far tried PLA,PETG ,ASA,PETG CF.
Thanks for the great product.
I have older machines that are absolute workhorses.
But the Taped unremovable plate made life difficult when the tape was new, prints had to be yeated out of the machine.
Now I just wait for the plate to cool, and the print just gently pops off the WHAMBAM PEX plate.
Also worth noting, I havent had the need to use a brim or raft for supports since getting the PEX plate for these machines.
The adheasion is incredible!